該裝置曝氣氣泡直徑小，氣液界面直徑小，氣液界面積大，氣泡擴散均勻，不會產生孔眼堵塞，耐腐蝕性強，經上海同濟大學環境工程學院和中國市政工程華北設計院進行清水和污水充氧測 試，并經50多家用戶多年使用效果良好（比常規產品固定螺旋曝氣器，散流曝氣器和穿孔管曝氣器能耗降低40%，或增加污水處理量40%）。特別適用于城市 污水和大型工廠新建擴建和老曝氣池改造，且曝氣池可間歇運行。
曝氣裝置由曝氣器、布氣管道、三通、四通、彎頭、調節器、連接件、清除裝置等組成。布氣管道按通常的環形布置，曝氣器按供氣量和池形布置密度，曝氣器和布 氣管道的連接采用G3/4螺紋連接，底座為內螺紋（固定于布氣管道上）曝氣器為外螺紋，安裝時先把調節器按所需尺寸用膨脹螺栓固定在池底，然后用抱箍把布 氣管道固定在調節器上，為防止其它作業如電焊火花和土建時，混凝土等重物 損壞曝氣裝置，必須等土建工程結束后在放水前把曝氣器裝上，為防止管道和連接部分漏氣，應放水超過曝氣器10cm左右底深度試漏，然后通氣如發現有管道連 接部分漏氣應及時排除，然后正式投運。
